I had nothing but trouble with this filament. Bed adhesion, blobbing, stringing, warping, and the biggest was the filament was constantly brittle and would break very easily. I really hope that it was just a bad roll, I have nothing but great things to say about the PLA I ordered from here. I understand PLA and PETG are two different beast, but I tried everything I could think of to no avail. I tried multiple settings, calibrations, temp towers, retraction towers, took apart my hot end, bought a steel nozzle x, tried cutting off feet at a time to combat the brittleness thinking it might have been moisture. Always stored my filament inside my house in a sealed dry box with 500g+ desiccant, eventually tried drying it in a 3d printer filament specific dryer and still couldn't get it to not be brittle. What was crazy is there would be a few inch of brittle filament about every foot or so and Im not sure but I think that is what caused a lot of my failed prints. If you notice brittle filament early, contact the company to try and resolve the issue early.