Menu
Cart

Table Top Ball Bearing Spool Holder

5 reviews

Atomic Filament

  • $ 999


High quality injection molded nylon table top spool holder with rubber grippy feet.

Price is for a set (2) as shown in picture.

Made in USA

Use this for our 1KG and 3.5KG rolls & others , smooth ball bearing payoff to feed your printer. Keep those heavy spools off the sides or top of your printer if needed.

Customer Reviews
3.2 Based on 5 Reviews
Write a Review Ask a Question

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
  • scratch
  • case
  • place
  • method
  • force
  • stop
  • rubber feet
  • rollers
  • filament roll
  • something
WH
09/04/2021
Wes H.
United States United States
I recommend this product
Works, but with a caveat.

These rollers put together well enough, but they are very light. The rubber feet are also not all that sticky. All this means that unless there is a secondary method to keep these from moving around, the force of the extruder pulling the filament can cause the rollers to slide around enough for the filament roll to fall off, especially if the filament roll becomes lighter due to filament running low (or tangled filament). In my case, I have built a stop that keeps these rollers in place. This works well enough that I haven't had issues with 3.5kg or 1kg rolls falling off. So, I would recommend these if you didn't want to make rollers from scratch but still have a way to keep them from sliding around, but if you just want something that would work out of the box they may disappoint.

09/09/2021
Atomic Filament

Like it Wes. Can you share the photo of what you are using?

S
08/05/2021
Steve
United States United States
I recommend this product
Cheap and don't work

These don't work. When the spool gets low it falls off. Tried many times. Just a bad design and cheaply made

RO
03/24/2021
Ryan o.
Works great

Works great for small and large rolls, I have this on a shelf next to the printer and it's so easy to swap rolls. Only complaint is a 1/4 full 1kg roll with a 1mm nozzle pulls a bit to hard and knocks it off. But I rarely use 1mm so not a huge problem

M
09/23/2020
Matt
Do not buy

I put a 1kg roll of filament (18mm wider than Atomic's 1kg roll) and mid print, the printer caused the rollers to slip, sending my roll crashing onto the floor exploding into a huge pile of spaghetti. I contacted Atomic and they said its better for 3.5kg than 1kg, even though the website says 1kg works fine. Thumbs down.

K
06/06/2020
Kevin
Amazing

Extremely good quality rolls like a dream with the huge 3.5 kg roll saved my life cause I kept wasting filament trying to get the old stand to work with it

Facebook retargeting pixel

We Also Recommend