Magigoo 3D Print Bed Adhesive
*** FRESH Stock***
Magigoo is your one solution for bed adhesion! Great 3D printer bed adhesion for most materials PLA , ABS , PETG.
MAGIGOO is easily cleaned with water – After each print the build plate should be cleaned using a damp cloth. This will remove excess build-up of MAGIGOO.
MAGIGOO’s adhesive properties are designed to release the 3D print once the build plate has cooled down. Once cooled, 3D prints can easily be removed without the use of tools and excessive force.
Magigoo is safe and non toxic.
Instructions click here
MSDS / SDS sheet click here
- glass beds
This works, there is a lot more in the small container than you think. This will last a really long time. The applicator works well. I am still not convinced it is any better than glue stick, but it is at at least as good. I would not hesitate to use this again.
I’ve debated throwing my cheap printer into a lake many times because my bed adhesion sucks. Started using magigoo after two years of toil and frustration and all my problems have finally gone. I’m actually excited about printing things again.
life / time / $$ - saver
LITERAL. GAMECHANGER. I had trouble with adhesion on my spring steel PEI bed, coding nearly everything with a raft because no matter how fine-tuned I had everything, the brims would only hold so long before my prints failed if they even stuck at all. I grabbed some Magigoo and another product a friend recommended; this arrived first so I gave it a try and HOT DANIEL. Not a single print failure on even the most intricate prints (brims only), and the first layers have been insanely clean and crisp with little to no clean up. 12/10 would recommend.
Waaaaaaaay better than glue sticks
Its pricey - but well worth it. So much better than using a glue stick. Really good adhesion without being overly tacky. I found that after the print is done to reheat the print bed to 70c the part pops right off with ease.
It's quite a gem, huh!
Way better than Purple Glue Stick
I don't wash this off after every print like the directions tell you to. If your Z is dialed in it will release the print and stay on the Creality Glass Bed (Carbowhatever). It's really helped my large, flat, and thin prints come out perfectly.
Courtney, we use it internally and also love it! Thanks for taking the time to review.
We Also Recommend